Speakman SEF-2001-8 Guide d'installation télécharger pdf (Page 4)

Retrieve the two (2) remaining supplied hoses. Take the first hose and

connect one end to the “E” port of the Supply Tee with no check

valves. Connect the remaining end to the 3/8” port of the HOT End

Body. Wrench tighten.

Retrieve the Supply Tee with no check valves. Connect the “F” port of

the Supply Tee to the remaining hose pre-installed in the base of the

SEF-2001. Wrench tighten.

Connect one end of the remaining hose to the blank port of the

Supply Tee with no check valves. Connect the remaining end to the

3/8” port of the COLD End Body. Wrench tighten.

NOTE: Before testing, you must remove tape from Eyewash Caps.

Turn on water supplies and check for leaks. Activate Eyewash by

lifting activation handle and check for proper function using the

chart at the the end of this document.

1 2 3 4 5 6

Pas de commentaire

Speakman SEF-2001-8 Guide d'installation Page 4