10/11
REV 2
92-3346
SPEAKMAN COMPANY
S-3018 Installation, Operation, & Maintenance Instructions
ANYSTREAM
®
SHOWERHEAD
DESCRIPTION
Polished chrome plated ANYSTREAM
®
S-3018 Showerhead. Spray adjusting T-handle. 4.6” square face. 5 self-
cleaning plunger nozzles resist scale build-up and provide 50 spray streams for a full body coverage pattern.
Center core nozzles deliver 8 pulsating-massage jets. There is also a dual action combination spray. Water
conserving pressure compensating AUTOFLO® device reduces flow to 2.5 GPM/9.46LPM maximum to meet
existing ASME A112.18.1/CSA B125.1 Standard. Brass threaded inlet with ½” NPT thread.
SPECIFICATIONS
SUPPLY INLET: ½” NPT
FLOW RATE: 2.5 GPM/ 9.46LPM MAXIMUM
SHIPPING WEIGHT: 1 LB.
INSTALLATION
Remove the old shower head from the shower arm. Clean off any debris on the threads of the shower arm. Wrap
Teflon tape around the shower arm threads in a clockwise direction. Turning in a clockwise direction, screw the
new Speakman shower head onto the shower arm. Tighten with a wrench. Turn the water supply on and check for
leaks.
OPERATION
To adjust the spray pattern of the showerhead, simply rotate the handle to the desired spray (Full-Body, Dual
Action or Massage).
Product improvements may cause
specification and dimensional
changes without notice.
MAINTENANCE
Periodic cleaning using mild soap and warm water will help keep your SPEAKMAN ANYSTREAM
®
showerhead’s
appearance in its original condition. For best results, dry immediately with a soft, clean cloth. Do not use harsh
and/or abrasive cleaners on showerheads. In certain water conditions, mineral deposits may form on your
faceplate. To reduce the mineral build-up, turn the handle to FLOOD position to let the water drain out after every
use. A gentle scrubbing of the plunger or channels with a toothbrush should restore your spray pattern. On
CHROME plated showerheads, white vinegar/water treatment will assist in breaking down excessive mineral
deposits on the sprays. The showerhead faceplate can be soaked in a two (2) parts white vinegar & (1) part water
solution for about ½ hour to break up the mineral deposits. Rinse thoroughly. Brush off any remaining mineral
deposits if necessary. CAUTION: On all special finish parts, including any of the NICKEL or BRASS finishes,
the white vinegar/water treatment should not be used.
OPTIONS
SPEAKMAN
®
PO Box 191 Wilmington, DE 19899 Phone: 800-537-2107 Fax: 800-977-2747
Visit us on the web at www.speakmancompany.com
ROUGH-IN MEASUREMENTS
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels