Speakman SEF-1850 Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Robinets Speakman SEF-1850. Speakman SEF-1850 Installation Guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 5
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
SEF-1850
SEF-1850-8
EYESAVER
Combination Faucet
Turn off water supply. Verify diameter of hole in countertop is a
minimum of 1-1/4”. Install mounting studs into base of faucet.
1
Install bottom washer over hoses and slide up to meet the base of
the faucet. Place hoses through hole in countertop/sink one at a time.
Place faucet with studs through hole.
Crescent
Wrench
Flat Head
Screwdriver
Keep the EYESAVER
faucet looking new by cleaning
it periodically with a soft cloth. Avoid abrasive
cleaners, steel wool, and harsh chemicals as these
will dull the finish and void your warranty.
Cover your drain to prevent loss of parts. Always
wear eye protection.
The supply line for this unit shall provide an
uninterruptible supply of flushing fluid at a minimum
of 30 psi flowing pressure. If shut off valves are
installed in the supply line of the eyewash, provisions
shall be made to prevent unauthorized shut off.
ANSI Z358.1 requires that all emergency equipment
shall be tested weekly to verify proper operation and
inspected annually to assure conformance with
ANSI Z358.1 requirements. Be sure to read
instructions thoroughly before beginning installation.
Do not overtighten any connections or damage may
occur.
92-SEF-1850-R3
®
2
®
Vue de la page 0
1 2 3 4 5

Résumé du contenu

Page 1 - EYESAVER

SEF-1850SEF-1850-8EYESAVERCombination FaucetTurn off water supply. Verify diameter of hole in countertop is a minimum of 1-1/4”. Install mounting st

Page 2

From beneath countertop, slide the rubber mounting washer, then brass mounting washer over the mounting studs. Thread two (2) brassnuts onto mounting

Page 3

Before installing aerator, turn on both hot and cold faucethandles. This will clear out any debris from the supply lines.Close both hot and cold fauc

Page 4 - Eyewash Flow Data

The faucet spout was designed to swivel from left to right. If a non-swivel spout is preferred, remove top cover from body. Next, remove allen head

Page 5 - ROUGH-IN MEASUREMENTS

ROUGH-IN MEASUREMENTS 4-1/2"in 7-5/8" 1-1/4" MINIMUM HOLE SIZE 20” (SEF-1850)18” (SEF-1850-8) (3 HOSES) 130° 2-5/8" 6-3/8&q

Commentaires sur ces manuels

Pas de commentaire